|
Cisco
Command Sender
This script is primarily designed to send any number
of "non-configuration" (e.g. show commands) commands
to a set of routers.
The set of routers can be as little as 1 or
hundreds or more!! Each command entered is verified that the
router did not report an error when entering the command.
When the script finishes, a summary log file
can be checked for any reported errors. If no errors were
present the summary log reports that the script ran successfully.
Although configuration commands can also be sent with this tool, the
Global Router Configurator utility has better error
checking for configuration commands.
Highlights
 | Option to save output of each router to a separate file. |
| Option to insert delay between the sending of specific
commands |
| The following commands which require confirmation are
supported:
| clear counters |
| clear log |
| reload |
| configure replace |
| write mem |
|
|
|
