Cisco
Global Configurator
This script can send any number of
configuration commands to a set of routers. The set of
routers can be as little as 1 or hundreds or more!! Each
command entered is verified that the router did not report an
error, warning, or informational message, after entering the command. In addition, another check is
performed which verifies the router did return an error when
exiting configuration mode. When the script finishes, a
summary log file can be checked for any reported errors.
If no errors were present the summary log reports that the
script ran successfully.
Also has the ability to send a different set of configuration
commands to each router using the "config_devices_rcf"
script. In a single file, you specify a list of routers (ip
addresses) along with a filename containing the commands to send
to that router. The script will cycle through all the
devices, sending the appropriate commands to each device.
This script also supports the "safe" and "supersafe"
options.
